Easy Low Cost No Radiation Fusion
Justin at Classical Values has put up a posts about fusion energy machines way different from the magnetic confinement and heating machines the government is building.
You can read the post here. Eric of Classical values has another post on the subject.
For more details on the physics visit EMC2 Fusion. You can also make a donation there to help the work go forward.
An interesting question is: when was the first steady state (operation times of at least 10s of seconds) electrically operated nuclear fusion machine which produces at least 10s of millions of fusions a second built? The astounding answer? 1959. So far 18 experimenters have produced similar machines including this young experimenter.
The next question is: why have advances been so slow in since then? The answer (and a lot more) is given in this video by Robert Bussard. (note: dial up is going to be incredibally slow as the video is around 1 hour and forty minutes - aproximately 170 mega-bytes) The video tends to the technical and I will have to study it a few times to get all the details. However a fair understanding of high school physics should suffice. Even if you don't understand the physics the general concepts are easy to understand and Dr. Bussard's enthusiasm is infectious.
In any case the idea is to build a fusion device that produces no long lived nuclear radiation and that works with the forces of nature instead of against them. The voltage required to make these devices work is on the order of 10 to 20 thousand volts or less. About the same voltage as you would find in a tube type monitor or TV set. Nothing very exotic. For a full scale power producer it is predicted that you would need about 2 million volts. Well within the range of current technology for small scale devices. Currently the highest voltage used in electrical transmission is 1.15 million volts. Scaling that up to two million volts for production devices should not be too difficult.
Near the end of the lecture (about 1 hour in)Dr.Bussard gets to the heart of the matter by listing the advantages of this type of power plant.
